Filter
Top Products
53
Changing the audio mode
Press the AUDIO SELECTOR button on the front panel (or AUDIO
button on the remote controller) to change the audio mode. Each
time the button is pressed, the mode changes from “Auto” →
“Multich” → “Analog” and back to “Auto.” The “Auto” audio mode
is recommended for normal circumstances.
Enjoying music or videos with the TX-DS797
Auto (automatic detection): With this setting, the TX-DS797
automatically detects whether the input signal is digital or analog.
When a digital signal is not input, then the analog signal is played.
Multich (Multichannel): Select this setting to play back the input
from the component connected to the MULTI CHANNEL INPUT
port. This setting is effective when the Multichannel setting in the
Multichannel sub-menu is set to “Yes” (see page 34).
Analog: Select this setting to play back the input from a source
component connected to an analog audio input jacks. With this
setting, even if a digital signal is input from the same component,
only the analog signal will be output.
3. Turn on the connected component and start playing
the desired media.
4. If necessary, adjust the output level of each speaker
as desired (see page 52).
Adjust the speaker output levels so that you can hear the same
sound level from each speaker at the listening position. For the
front right, front left, center, surround right, and surround left
speakers, the output levels can be adjusted between –12 to +12
decibels. The subwoofer can be adjusted between –30 to +12
decibels.
5. Adjust the volume with the MASTER VOLUME dial or
the VOL
buttons on the remote controller.
TX-DS797 Remote controller
TX-DS797 Remote controller
TX-DS797 Remote controller
Enjoying the multichannel output
Before starting operations, first make sure that the multichannel
connection is properly made and that the Multichannel setting of the
Input Setup → Multichannel Setup sub-menu to “Yes.”
1. Press the input source button for the component with
multichannel output connected to the MULTI
CHANNEL INPUT on the rear of the TX-DS797.
2. Select “Multich” using the AUDIO SELECTOR button
on the front panel (AUDIO button on the remote
controller).
STANDBY/ON
OFF
ON
POWER
STANDBY
PHONES
MASTER VOLUME
FM AM PHONO C
DTAPE
VIDEO
4 VIDEO 5VIDEO 3VIDEO 2VIDEO 1
DVD
OFFZONE 2REC OUTDISPLAY DIMMER
UPSAMPLING
AUDIO
SELECTOR
ZONE 2
()
GRN
REC
()
RED
S VIDEO AUDIO
VIDEO L R
DIGITAL
CLEAR
VCR 2VCR 1
VIDEO 5/VIDEO CAM INPUT
DSP
A
-
FO
RM LISTENING MODE MEMORY
THX
SURROUNDDIRECT STEREO
MEMORY
FM
MODE
ENTER
RE
TURN
SETUP
TUNI
NG
PRESET
AV
RECEIVER
TX
-
DS797
AUDIO SELECTOR
DIRECT
AUDIO
MASTER VOLUME
DIRECT
VOL
AUDIO
SELECTOR
AUDIO
SELECTOR
MASTER VOLUME
Input source buttons
Using the tone control:
Each time you press the DIRECT button on the remote controller,
the display changes from “Direct”→“Tone On.” To make bass and
treble adjustment work for multichannel sources, you must first set
the tone control to “Tone On.”
1. Press the DIRECT button (or DIRECT button on the
remote controller) to display “Tone On.”
When pressed only once, the current setting appears, so press
twice to change the setting.
2. Adjust the tone at the Setup menu: Audio Adjust →
Tone Control.
Note:
Adjusting the volume level of each speaker for the MULTI CH
INPUT source does not affect the speaker level adjusted by the
listening position.
DIRECT
TX-DS797 Remote controller