Filter
Top Products
38
Connecting Your Components
—Continued
The AV receiver has AC outlets on its rear panel that can
be used to connect the power cords of other components
that you intend to use with the AV receiver. These com-
ponents can then be left turned on so that they turn on
and off as and when the AV receiver is turned on and set
to Standby.
Caution:
• Make sure that the total capacity of the components
that you connect to the AC OUTLETS does not exceed
the stated capacity (e.g., TOTAL 120 W).
Note:
• Onkyo components connected via should be con-
nected directly to a wall outlet, not an AC OUTLET on
the AV receiver.
• The number of AC OUTLETS, socket type, and total
capacity depends on the country in which you pur-
chased the AV receiver.
American and Australian models do not have this port.
This port is for connecting the AV receiver to home auto-
mation equipment and external controllers.
• Before connecting the power cord, connect all your
speakers and AV components.
• Connect the AV receiver’s power cord to a suitable
wall outlet.
•Turning on the AV receiver may cause a momentary
power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the AV receiver into a different branch circuit.
Connecting the Power Cords of Other
Components
AC OUTLETS
AC
120
V 60
Hz
SWITCHED
TOTAL 120W 1A MAX.
AC
OUTLETS
AC 230
-
240
V 50
Hz
SWITCHED
TOTAL 100
W MAX.
European and some
Asian models
American model
Connecting the RS232 Port
Connecting the Power Cord