Onkyo TX-SR701E Stereo Receiver User Manual


 
21
Connections
9. Connecting video camera, etc. (VIDEO 4 INPUT)
Using an RCA video cable, connect the video output jack
(composite) of the device to the VIDEO 4 VIDEO jack of the TX-
SR701/701E/601/601E. Or if the device has an S video output jack,
connect it to the VIDEO 4 S VIDEO jack of the TX-SR701/701E/
601/601E using an S video cable.
Using an RCA audio cable, connect the audio output jack of the
device to the VIDEO 4 AUDIO jacks of the TX-SR701/701E/601/
601E. Make sure that you properly connect the left channel to the L
jack and the right channel to the R jack.
If the device has an optical digital output, connect it to the VIDEO 4
DIGITAL jack of the TX-SR701/701E/601/601E.
The VIDEO 4 digital input is fixed to the OPTICAL input on
the front panel.
When the TX-SR701/701E/601/601E is in the ZONE 2 mode, this
terminal outputs at 12 V/100 mA.
12V TRIGGER ZONE 2 terminal
S Video output
Digital output
(optical)
9. Video camera/ Video game
(VIDEO 4 INPUT)
Video output
Analog output
R (red)
L (white)
These jacks are for connecting an auxiliary power amplifier.
You can use an auxiliary power amplifiers to listen at louder
volumes than you can with the TX-SR701/701E alone. When using
a power amplifier, connect each speaker to the power amplifier.
Note:
If you use a power amplifier connected to the SURR BACK PRE
OUT terminal and connect two surround back speakers to the
amplifier, set the “Hardware Config” “b. Surr Back” setting to
“2ch (PRE OUT)” (see page 55).
PRE OUT (TX-SR701/701E only)
SUR
BAC
SPE
FRONT SURR CENTER SURR BACK
(SB)
ZONE 2
SUB
WOOFER
PRE OUT
R
L
R
L
6521 43 87
1. Front right speaker
2. Front left speaker
3. Surround right
speaker
4. Surround left speaker
5. Subwoofer
6. Center speaker
7. Surround back right
speaker
8. Surround back left speaker
L (white)
R (red)
Power amplifier
R (red)
L (white)
L (white)
R (red)
Subwoofer
Surround
Front
Center
Surround back