Filter
Top Products
72
Advanced Setup—Continued
SW Input Sensitivity
Some DVD players output the LFE channel from their
subwoofer output at 15 dB higher than normal. You can
change the subwoofer sensitivity to match your DVD
player. Note that this setting only affects signals con-
nected to the SUBWOOFER input jack of the multi-
channel DVD input.
You can select 0 dB, 5 dB, 10 dB, or 15 dB.
If you find that your subwoofer is too loud, try the 10 dB
or 15 dB setting.
Here you can set listening mode-related settings and
functions.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Multichannel DVD Input Settings
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “8. Hardware
Setup,” and then press [ENTER].
Use the Up and Down [ ]/[ ]
buttons to select “SW Input Sen-
sitivity,” and use the Left and
Right [ ]/[ ] buttons to select a
value.
3
Press the [SETUP] button.
Setup closes.
RECEIVER
SETUP
SETUP
Audio Adjust Functions
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “5. Audio
Adjust,” and then press [ENTER].
The Audio Adjust menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select the settings,
and use the Left and Right [ ]/
[ ] buttons to set them.
The settings are explained on page 73.
4
When you’ve finished, press the
[SETUP] button.
The setup menu closes.
SETUP
RECEIVER
5.Audio Adjust
------------------------
a.Multiplex : Main
b.Mono Input Ch: L+R
c.PL x Panorama :Off
d.PL x Dimension : 0
e.PL x Center Width:3
f.Neo:6 CenterImage:2
g.Dolby EX : Auto
h.T-D Listening Angle
: Wide
SETUP