Filter
Top Products
En-3
The receiver allows you to update the firmware using a
USB device.
Notes:
• Never unplug or turn off the receiver during the update
process.
• Never plug or unplug a USB device during the update
process.
• Never unplug the USB storage device containing the
firmware file or the AC power cord during the update
process.
• Do not attempt to access the receiver from your PC
while it is being updated.
• It takes about 5 minutes to complete the firmware
update.
• The receiver will retain all your settings after the
update is finished.
Before you start
• Turn off the controller device connected via Ethernet
cable.
• Turn off Zone 2.
• Stop playback of contents from Internet Radio, iPod/
iPhone, USB or servers, etc.
• If there is any data in the USB device, remove it first.
Update procedure
1
Connect a USB device to your PC. If there is
any data in the USB device, remove it first.
2
Download the firmware file from the Onkyo
web site. The file name is as follows:
ONKRCV****_************.zip
Unzip the downloaded file. The following some/
any files are created:
ONKRCV****_************.of1
ONKRCV****_************.of2
3
Copy the extracted files to the USB device.
Be careful not to copy the zip file.
4
Remove the USB device from your PC and
connect it to the USB port on the receiver.
5
Make sure the receiver is turned on.
If the receiver is in standby mode, press [ON/
STANDBY] on the receiver to light the front
display.
6
Select the USB input source.
“Now Initializing” is displayed on the front display
and then the name of the USB device is displayed.
It takes 20 to 30 seconds to recognize the USB
device.
7
Press the [SETUP] button on the remote
controller.
Setup menu will be displayed on the front display.
The procedures thereafter can also be performed on
the receiver by using its [SETUP], arrow and
[ENTER] buttons.
8
Use [] or [] button to select “6.Firmware
Update” and press [ENTER].
9
Use [] or [] button to select “via USB”
and press [ENTER].
10
Use [] or [] button to select “Update”
and press [ENTER].
The update process will begin.
During the update process, you can still view the
update progress on the front display of the receiver.
Do not turn off the receiver and do not remove the
USB device during the update process.
11
The message “Completed!” appears on the
front display of the receiver, indicating that
the update has been completed.
Remove the USB device.
12
Turn off the receiver using
[ON/STANDBY] on the front panel.
Do not use [] on the remote controller.
Once turned off, the receiver will automatically
turn on again.
Congratulations! You now have the latest firmware
installed on your Onkyo receiver.
Updating the Firmware via USB