Onkyo SKS-HT235 Speaker System User Manual


 
En-
8
Connecting the Speakers
Read the following before connecting your speakers:
•Turn off your amp before making any connections.
The nominal impedance of these speakers is 8
. Use
only an amp that supports this impedance.
•Pay close attention to speaker wiring polarity. Connect
positive (+) terminals to only positive (+) terminals,
and negative (–) terminals to only negative (–) termi-
nals. If the speakers are wired incorrectly, the sound
will be out of phase and will sound unnatural.
Be careful not to short the posi-
tive and negative wires. Doing so
may damage your amp.
Connecting the Speaker Cables
1
Use the cables to connect each speaker’s
input terminals to the corresponding
speaker output terminals on your amp.
To make a connection, while
pressing the terminal lever,
insert the wire into the hole, and
then release the lever.
Make sure that the terminals are
gripping the bare wires, not the insulation.
Connecting the Subwoofer
1
Using the supplied RCA cable, connect
the subwoofer’s LINE INPUT to your amp’s
SUBWOOFER PREOUT.
REMOTE
CONTROL
OUT
2 ––VIDEO –– 1 VIDEO 2 VIDEO 1
IN
IN IN
IN
OUT
OUT
IN OUT IN
IN
IN
VIDEO2
CDR/PC
VIDEO 1 TAPE
MD/HD
TV/LINE
MON
OUT
MON
OUT
L
R
VIDEO
S VIDEO
AUDIO
SUB
WOOFER
PRE OUT
AUDIO
FM
75
ANTENNA
DIGITAL
OUTPUT
DIGITAL INPUT
VIDEO 2 VIDEO 1
OPT
OPT
COAX
AM
Y
P
B
P
R
COMPONENT VIDEO OUTPUT
CENTER
SPEAKER
SURROUND
SPEAKERS
R
L
R
L
R
BA
L
FRONT SPEAKERS
LINE
INPUT
Front right
speaker
Center
speaker
Front left
speaker
Surround
right speaker
Powered
subwoofer
Surround
left speaker
Red
Green
White
Blue
Gray
RCA cable
SKS-HT235.book Page 8 Friday, June18, 2004 9:05AM