Filter
Top Products
En-
5
Getting to know Your Speaker Package
A
POWER switch and indicator
To turn on the SKW-240, set the POWER switch to
the ON position (the indicator lights up).
To turn off the SKW-240, set the POWER switch to
the OFF position (the indicator goes out).
Red: The unit is in standby mode
Green: The unit is in operation mode
The SKW-240 automatically turns to Standby mode
when no signal has been input for about 20 minutes.
The SKW-240 automatically turns on when an input
signal is detected in Standby mode.
B
OUTPUT LEVEL control
This control is used to adjust the output level of the
subwoofer.
C
LINE INPUT
The RCA input should be connected to the sub-
woofer preout on your AV receiver, amp, or other
receiver with supplied RCA cable.
Note:
The Auto Standby function turns the subwoofer on when
the input signal exceeds a certain level. If the Auto
Standby function does not work reliably, try slightly
increasing or decreasing the subwoofer output level on
your receiver or amp.
1
Speaker terminals
These push terminals are for connecting the speaker
to your amp, or other receiver with the supplied
speaker cables. The supplied speaker cables are
color-coded for easy identification. Simply connect
each cable to the same-colored positive speaker ter-
minal.
2
Keyhole slots
These keyhole slots can be used to wall-mount the
speaker either horizontally or vertically.
3
Speaker mount/bracket inserts
These threaded inserts can be used to attach the
speaker either horizontally or vertically to a speaker
mount or bracket.
Note:
Use commercially available M5 screws to attach the
speaker to a speaker mount or bracket.
4
Base inserts (other than center speaker)
These threaded inserts can be used to mount the
speaker on the supplied base (screws included).
Subwoofer (SKW-240)
1
OUTPUT
LEVEL
LINE
INPUT
MIN
MAX
2 31
POWER
ON OFF
■
Front
■
Rear
Front, Center & Surround Speakers
(SKF-404F, SKC-404C, SKM-230S)
2
4
1
3
SKS-HT235.book Page 5 Friday, June18, 2004 9:05AM