Filter
Top Products
10
(B) Recording the same program simultaneously on cassettes in both Deck A and Deck B (TA-RW544
only)
Procedure for recording
1. Prepare for recording.
(See page 8.)
2. Press the RESET button to return
the tape counter for both Deck A
and Deck B to [0000].
• To change the active deck, press the
DECK A/B button.
3. Begin playing the source compo-
nent.
4. Press the Deck A and Deck B
t buttons.
5. While observing the peak level
indicators, adjust the recording
level and balance.
• Use the REC LEVEL knob to adjust the
recording level.
• Adjust the REC BALANCE knob so
that the left and right channels have
approximately the same levels. This
knob is normally at the center position.
6. Put the source component into
recording standby status.
7. Press the Deck A or Deck B s
button and begin playing the
source component.
You can also use the CD Synchro
Recording function if this unit is
properly connected to an ONKYO
CD player bearing the z symbol.
(See page 14.)
Notes:
• The following buttons and knob affect
both Deck A and Deck B.
— The REVERSE MODE button
— The DOLBY NR button
— The REC LEVEL knob and REC
BALANCE knob
• The auto space function operates both
Deck A and Deck B at the same time.
And, pressing the a , s or t
button on either Deck A or Deck B
affects both Deck A and Deck B.
4
5
3
2
Stopping recording
To stop recording on Deck A or Deck B
only, press the appropriate deck e button.
s
or
B
A
DECK A/B RESET
DECK A/B RESET
t
t
e
DUBB. STOP
e
6
7
e
s
REC BALANCE REC LEVEL
L R MIN
MAX
DECK-A
REC
PAUSE
-
-20 -10 -6 -3
0
+3 +6
B
C
DOLBY NR
REC
PAUSE
DECK-B
L
R
dB
DECK-A
REC
PAUSE
-
-20 -10 -6 -3
0
+3 +6
B
C
DOLBY NR
REC
PAUSE
DECK-B
L
R
dB
27
45