Filter
Top Products
54
Advanced Setup
—Continued
Speaker Levels
With this function, you can adjust the volume of each
speaker so that all speakers can be heard equally at the
listening position.
Note:
•A quicker way to adjust the speaker levels is to press
the remote controller’s [TEST TONE] button to output
the test tone, use the [LEVEL–] and [LEVEL+] but-
tons to adjust the levels, and use the [CH SEL] button
to select the speakers.
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button on
the remote controller.
2
Use the Up and Down [ ]/[ ]
buttons to select “4. Level Cal,”
and then press the [ENTER] but-
ton.
A pink noise test tone is output by the
front left speaker.
3
Use the Left and Right [ ]/[ ]
buttons to adjust the speaker
level, and use the Down [ ] but-
ton to select the next speaker.
The level can be adjusted from –12 to
+12 dB in 1 dB steps (–15 to +12 dB
for the subwoofer).
• The speaker levels cannot be adjusted while
a pair of headphones is connected, speaker
set B is on, or the AV receiver is muted.
• Because the AV receiver supports THX, the
test tone is output at the standard level of
0 dB (relative volume setting 0). If you nor-
mally listen at volume settings below this, be
careful because the test tone will be much
louder.
SETUP
RECEIVER
4
Repeat step 3 so that the level of
the test tone from each speaker
is the same.
Speakers that you set to No in the
Speaker Configuration (page 55) do not
output the test tone.
If you’re using a handheld sound level
meter, adjust the level of each speaker
so it reads 75 dB SPL at the listening
position, measured with C-weighting
and slow reading.
5
Press the [SETUP] button.
Setup closes.
Don’t forget to turn down the volume if
you turned it up while setting the levels.
SETUP