Filter
Top Products
81
Zone 2—Continued
If you’ve connected your Zone 2 speakers to the AV
receiver, as explained in “Connecting Your Zone 2
Speakers Directly to the AV receiver” on page 80, you
must set the “PwrdZ2” (Powered Zone 2) setting to
“Act” (Activated).
Notes:
• When “Act” is selected and Zone 2 turned on, the
Zone 2 speakers connected to the ZONE 2
SPEAKERS L/R speaker terminals output sound, but
the surround back speakers connected to the SURR
BACK L/R speaker terminals do not. When “Act” is
selected and Zone 2 turned off, the surround back
speakers output sound as normal.
• When the “Powered Zone 2” setting is set to “Act” and
the input selector of Zone 2 is selected, power con-
sumption on standby mode slightly increases.
• “Powered Zone 2” cannot be used if “Sp Type” is set
to “Bi-Amp” (page 44).
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
Setting the Powered Zone 2
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
2
Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Setup”, and then press [ENTER].
SETUP
RECEIVER
ENTER
3
Use the Up and Down [ ]/[ ]
buttons to select “2-1. Sp
Settings”, and then press
[ENTER].
4
Use the Up and Down [ ]/[ ]
buttons to select “PwrdZ2”.
5
Use the Left and Right [ ]/[ ]
buttons to select:
Not Act: ZONE 2 SPEAKERS L/R
speaker terminals not
activated (Powered Zone 2
disabled).
Act: ZONE 2 SPEAKERS L/R
speaker terminals activated
(Powered Zone 2 enabled).
6
Press the [SETUP] button.
Setup closes.