Filter
Top Products
85
Zone 2—Continued
Adjusting the Volume for Zone 2
Muting Zones
Notes:
• Only analog input sources are output by the ZONE 2
LINE OUT and ZONE 2 L/R speaker terminals. Dig-
ital input sources are not output. If no sound is heard
when an input source is selected, check if it’s con-
nected to an analog input.
• While Powered Zone 2 is being used, listening modes
that require surround back or front high speakers (6.1/
7.1), such as Dolby Digital EX, DTS-ES and Dolby
Pro Logic IIz Height are unavailable.
• While Zone 2 is on, functions will not work.
• You cannot select different AM or FM radio stations
for your main room and Zone 2. The same AM/FM
radio station will be heard in each room. For example,
if you have an FM station for the main room, that sta-
tion will also be used in Zone 2.
• Zones can also be unmuted by adjusting the volume.
• When the “Powered Zone 2” setting is set to “Act”
and the input selector of Zone 2 is selected, power
consumption on standby mode slightly increases.
Remote
controller
On the remote controller, press
the [ZONE 2] button, and then
use the VOL [ ]/[ ] button.
AV receiver
On the AV receiver, press the
[ZONE 2] button, and then use
the [–]/[+] buttons.
If your Zone 2 speakers are connected
to a receiver or integrated amp in Zone
2, use its volume control to adjust the
volume.
Remote
controller
On the remote controller, press
the [ZONE 2] button, and then
press the [MUTING] button.
To unmute a zone, on the remote
controller, press the [ZONE 2]
button, and then press the
[MUTING] button again.