Filter
Top Products
En-1
E
n
5.1ch Home Theater Speaker Package
Make sure you have the following accessories.
Front speakers (SKF-680)
*1
Configuration of the rubber stoppers may be different from the
figure, such as being 2 sheets instead of 1 sheet, but the total
number will be same.
Center speaker (SKC-680)
Surround speakers (SKR-680)
Powered subwoofer (SKW-791)
Caution
• The front grilles are not designed to be removed so do not
attempt to remove them forcibly, as this will damage
them.
■ Front
■ Rear
Note
• The Auto Standby function turns the subwoofer on when the
input signal exceeds a certain level. If the Auto Standby function
does not work reliably, try slightly increasing or decreasing the
subwoofer output level on your receiver.
Supplied Accessories
Front speakers
Speaker cables 11 ft. (3.5 m)
20 rubber stoppers
*1
(For Front/Center/
Surround speakers)
Center speaker Speaker cable
10 ft. (3.0 m)
Surround speakers
Speaker cables 26 ft. (8.0 m)
(White)
(Red)
(Green)
(Blue)
(Gray)
Subwoofer RCA cable
10 ft. (3.0 m)
4 floor pads
Part Names
Speaker terminals
Keyhole slot
SKF-680/SKR-680
Speaker terminals
Keyhole slots
SKC-680
Status indicator
Off: Subwoofer in standby mode or
disconnected from power source
Blue: Subwoofer on
With the Auto Standby function, the
SKW-791 automatically turns on when an
input signal is detected in standby mode.
When there’s no input signal for a while,
the SKW-791 automatically enters
standby mode.
SKW-791
To AC outlet
OUTPUT LEVEL control
This control is used to adjust the
volume of the subwoofer.
LINE INPUT
This RCA input should be
connected to the subwoofer pre
out on your AV receiver with
supplied RCA cable.
SKW-791
HTP-691