Filter
Top Products
20
Connecting Other Components—Continued
The following diagram shows how to connect an optional Onkyo CD recorder.
Connect the CD receiver’s DOCK/CDR OUT jacks to the CD recorder’s INPUT (REC) jacks, and connect the CD
receiver’s DOCK/CDR IN jacks to the CD recorder’s OUTPUT (PLAY) jacks.
What can you do with ?
• Connecting an Onkyo CD recorder to the CD receiver with an cable allows you to control the CD recorder with
the CD receiver’s remote controller. In addition, when playback is started on the CD recorder, the CD receiver will
automatically select it as the input source.
•To use , you must connect the Onkyo CD recorder to the CD receiver with an cable and an analog audio cable
(RCA). In addition, the Input Display for the DOCK/CDR jacks must be set to “CDR” (see page 27).
• Some -capable components have two jacks. They’re both the same, so you can use either one. The extra jack
is for connecting additional -capable components.
Connecting an Onkyo CD Recorder
IN
IN
R
LINE 1
MD/
TAPE
L
IN
OUT
OUT
DOCK/
CDR
(REC) (PLAY)
INPUT OUTPUT
REMOTE
CONTROL
L
R
: Signal flow
Onkyo CD recorder’s
rear panel
Analog audio cable (RCA)
cable supplied with
the Onkyo CD recorder
White
Red
White
Red Red
Red
White White
CD receiver’s
rear panel