Filter
Top Products
13
Handling
Handling and maintenance of stylus
Take due care when handling the stylus as the stylus tip
is extremely delicate.
Remove any dust attached to the stylus tip using a brush
with a soft tip by brushing from the base of the stylus
towards the end. You can also use a special cleaner
available commercially for cleaning.
Replacing the stylus
The life-span of the stylus is normally about 500 hours but
varies greatly depending on the usage conditions. When
the stylus tip is worn out, high frequencies may go out of
pitch or the record may be damaged. Promptly replace
the stylus in this case. Use a special replacement stylus
(DN-105ST) to replace the stylus for the CP-1050. See
the manual supplied with the replacement stylus for the
replacement method.
Maintenance of records
Use a commercial record cleaner to wipe the records
thoroughly. If the record is dirty, the stylus may be
damaged, resulting in noise and jumping sounds.
When relocating the unit
Repackage the unit in the packaging it came in. If you no
longer have the packaging, do the following:
0
Take off the turntable and rubber mat and carefully
wrap them.
0
Remove the counterweight and head shell from the
tone arm and carefully wrap them.
0
Secure the tone arm with the arm clamp and then tie it
with a string so that it does not move.
0
Carefully wrap the unit in a blanket or soft paper.