Filter
Top Products
11
Playing records
1. Press the POWER button to turn on the power
supply.
The indicator of the speed selector button lights up.
2. Put a record on the rubber mat.
0
If it is a record with a
large hole, fit the
supplied adapter for 45
rpm records into the
center spindle.
3. Set the speed selector button according to the record’s
playing speed.
“33”: 33 1/3 rpm record
“45”: 45 rpm record
The indicator of the selected speed selector button
lights up.
4. Press the START/STOP button.
The turntable starts revolving.
5. Raise the lifter lever, hold the head shell’s finger hook,
and move the tone arm to the desired position over the
record.
6. Lower the lifter lever.
The tone arm will slowly descend until the stylus tip
touches the record and start playing the music.
0
When lowering the stylus onto a record, keep the
amplifier volume low so as not to create large
noises and adjust the volume after the stylus tip
touches the record.
To stop playing the music
1. Lower the volume of the amplifier and then raise the
lifter lever.
0
Lower the lifter lever to start playing the music
again.
2. Hold the finger hook of the head shell and lower the
lifter lever after returning the tone arm to the arm rest.
3. Press the START/STOP button.
The turntable stops revolving.
0
The player will not stop automatically even when
the record has finished playing.
0
Wait until the turntable stops revolving before
replacing records.
0
Secure the tone arm with the arm clamp if you are
not going to start playing the next tune immediately.
4. Press the POWER button to turn off the power
supply.
0
Put on the stylus cover to protect the stylus tip if you
are not going to use it for a while.
Before playing the music
0 Release the arm clamp.
0 Turn on the power supply of the connected
amplifier and switch the input so that the sound of
this unit comes out. Keep the volume of the
amplifier low.
POWER button Speed selector
button
START/STOP
button
For European models
Auto-standby function: If the unit is not operated for
about an hour with the turntable stopped, it will
automatically go into the standby mode. (The indicator
of the speed selector button will go off.) Power
consumption is reduced in the standby mode.
Press the START/STOP button or the speed selector
button in the standby mode to return to the power on
state.
Lifter lever