Filter
Top Products
14
Fig. 13
+
-
POWER
12VDC/0.4A
CONNECT TO
PC
CONNECT TO
CONCERTO D
IR
EMITTER
IR
BLASTER
Concerto Learning Station
Model NV-I8DLS
PASSTHRU
READY
IR SENSOR
TEST ACTIVE
POWER
When the remote code is entered, the IR Library Record
window will go from yellow to green and indicate that the
capture was successful, and it will then return to yellow.
Repeat this procedure three more times until the desired
code is added to the IR Library Edit window. You will now see
the number of code repeats and the duration of the code. A
normal non-toggling remote will require two button pushes
to successfully record a command, while a toggling remote
will require four button pushes for each command.
If there is an error in recording the code, the display in the
Record window will indicate that there was a communication
error. If this occurs, click on the Record button and reenter
the code.
Fig. 14
2.3 IR Library Default Key Assignment (Fig. 15)
Once the desired codes are added, assign them to the
appropriate key on the Control Pad. Note that by design, the
Control Pad has only 3 IR programmable function keys and
Power ON/Power Off. Access to multiple preset choices will
be covered later in the Macros section.
To assign default IR functions to the Control Pad buttons,
right-click on each code and select “Keys.” This opens a
drop-down menu of the possible key selections for the
Essentia Control Pad. Select the appropriate key for that
command and the Configurator will add it to the Default Key
field for that command. The Play/Pause, Prev. and Next
functions have an additional (Held) function. This allows an
additional function assignment that is activated when the
button is held. The Control Pad automatically displays the
function being sent to the source component.
Once this sequence is completed, proceed to the next
function command, and repeat the above steps. When you
have assigned a default key for each IR, click on “Done” and
that component's IR Library is complete.
You can also assign discreet power on and off commands.
The Essentia System will initiate the On command when a
zone is turned on and in turn initiate the Off command when
the zone All Off function (holding the Power button for three
seconds) is initiated from any of the Control Pads.
Fig. 15