Filter
Top Products
PRO TT-1
REAR PANEL DIAGRAM...
41
42
43
44
45
46
47
40
40. Removable Lid - Protects the turntable from dirt and
dust.
41. Hinge Assembly - Holds the lid and turntable together.
Attach now by sliding the bottom tabs of the Hinge
Assembly into the Hinge Holders (10).
42. Platter Speed Output - This output is to be used with
external devices the require platter speed information.
43. Remote Start/Stop - This is used with external control
devices.
Tech note: This circuit is a normally open, use a
momentary switch and a 1/4” mono plug to change
play states of the unit.
44. Adjustable Feet - Turn feet to level the platter surface.
45. Phono Output - Plug these into your mixer or
preamplifiers’ turntable input.
46. Ground Cable - Attach to the ground screw on your
mixer or preamplifier to prevent turntable hum.
47. Power Cord - Plug this into an appropriate power outlet
after checking your power setting switch (18) under the
platter.
Note: Please refer to CAUTION on page 2 concern
proper use of power
Your assembly should now be complete. Place your turntable on a
vibration free level surface and attach to your mixer or preamplifier. If you
are using the turntable for slip cueing or mixing music you will want to use
the slipmat and not the rubber mat.
- The Leader in DJ Technology
©1999 Industries 9 http://www.numark.com