Filter
Top Products
61
Step 1 - Press and hold the PROGRAM button
for two seconds.
Three LEDs illuminate: ENTER IR,
PROGRAM, and SOURCE 2.
The POWER OR DISCRETE
“ON” LED blinks.
Step 2 - If Source Two is turned ON/OFF
with IR commands, go directly to
Step 3.
If Source Two is not turned ON/OFF via
IR Commands, press the
NEXT button
twice and move ahead to Step 8.
Two LEDs illuminate:
PROGRAM and SOURCE 2.
The IR COMMANDS LED blinks.
Step 3 - Teach the POWER OR DISCRETE “ON”
IR command from Sour
ce
T
wo’s factory remote
control into the IR Sensor
W
indow.
Three LEDs are illuminated:
ENTER IR, PROGRAM, and SOURCE 2.
T
he
PO
WER OR DISCRETE
“ON” LED blinks.
T
he
ENTER IR LED blinks once after the IR command
is received and remains illuminated.
SYSTEM PROGRAMMING STEPS
PROGRAMMING THE SOURCE COMPONENTS