Filter
Top Products
15
S TEREO A MPLIFIER/ AUTOMATED S WITCHER
Installation
Caution
: Turn the power OFF to all components in the system
to prevent accidental shorting or electrical shock.
Mounting the TVA50
When possible, the TVA50 should be installed near the device
to be switched. An unswitched 120VAC outlet is required to
power the TVA50. (Unit should remain unplugged during
installation.) Care should be taken to provide adequate space
for access and connections.
Horizontal (Shelf) Mount.
Install the supplied self adhesive rubber feet to the bottom of
the TVA50. The unit can be placed on top of a shelf in a wall
unit or equipment cabinet. Nothing should be placed on top of
the unit.
Vertical (Wall) Mounting.
The unit can also be attached to the side wall or back panel of
a wall unit or equipment cabinet using the keyholes on the
back of the TVA50.
1. Using a level and tape measure, install four drywall screws
according to the measurements shown in Figure 6.
2. Align the keyholes on the back of the TVA50 with the
mounting screws and slide the unit down until it locks.
DS00395ACA-TVA50.qxp 6/1/04 9:51 AM Page 15