Filter
Top Products
16
WWW.NILESAUDIO.COM
INSTALLATION
AC pOwER pLUG
CAUTION! Typically a preamp/receiver’s switched outlet is not rated for a power
amplier. The SI- 250, the SI-2100 and the SI-2150 draw 200 watts, 300 watts,
and 400 watts maximum from an AC wall outlet respectively. Use a dedicated
AC wall outlet along with the amplier’s auto turn on circuit to ensure adequate
power.
STEP DESCRIPTION
1. Plug the female IEC socket of the
supplied AC power cord (the supplied
power cord is designed for 120V AC
wall outlets), or use an appropriate
IEC AC power cord to match the
electrical wall outlet you are using
(e.g. 240V AC), into the IEC receptacle
on the rear of the amplifier.
Just like a computer or printer, the
Niles System Integration Amplifier
®
has an AC cord which unplugs
either at the amp or at the wall for
your convenience.
2. Plug the male end of the AC power
cord into a correctly grounded wall
outlet.
If you use a grounded power strip,
surge suppressor or extension
cord, verify that proper ground is
maintained.