14
INSTALLATION
AC Power Plug
STEP
Plug the female IEC socket of
the supplied AC cord into the IEC
receptacle on the rear of the amplifier.
Plug the two-prong plug into
230V 50 Hz wall outlet.
CAUTION! TYPICALLY THE PREAMP/
RECEIVER’S SWITCHED OUTLET
IS NOT RATED FOR A POWER
AMPLIFIER.
Just like a computer or printer, the SI-2125
has an AC cord which unplugs either at the
amp or at the wall for your convenience.
If you use a grounded power strip, surge
suppressor or extension cord, verify that
proper ground is maintained.
The SI-2125 draws a maximum of
approximately 700 watts from an AC
wall outlet. Use the auto turn on circuit
instead.