Filter
Top Products
7
T
ABLETOP STEREO
V
OLUME
C
ONTROL
6. Insert each wire into the appropriate hole on the removable
connector plug, and snap the locking tab down.
NOTE: To help you avoid improper installation, the
connector plug is keyed.
AMPLIFIER SPEAKER
Niles Audio Corporation Miami, Florida USA
1
SPEAKER PAIRS
5/6
2
3/4
TUNER 94.9
15
Niles TVC-1
Receiver
Speaker Pair
Figure1
Wiring Diagram
Type of Speaker Wire
For most applications, we recommend you use 16 or
18 gauge, stranded copper speaker wire for the TVC-1 con-
nections. For wiring runs longer than 80 feet, 14 gauge wire
is recommended. Using speaker wire larger than 14 gauge for
the TVC-1 connections is not recommended—the wire may
not fit into the connectors. Never use solid-core, aluminum,
or “Romex” type wire with the TVC-1. When running speaker
wires inside walls, most states and municipalities in the U.S.
specify that you must use a special type of speaker wire .
Usually, the requirement is that the wire has a specific “CL”
fire rating, such as “CL-2” or “CL-3”. Consult your Niles deal-
er, building contractor, or local building and inspection
department if unsure about which type of wire is best for
your application.
Avoiding Interference
Speaker wires can act as an “antenna” for electrical noise.
Locating speaker wires too close to a light dimmer or switch
may cause a “buzzing” or "popping" sound to be heard
through the speakers. If you must locate the TVC-1 wiring
near electrical devices, route the speaker wires several feet
away from the electrical wiring.
4
T
ABLETOP STEREO
V
OLUME
C
ONTROL
IMPORTANT
DO NOT use the
TVC-1 with amps
or receivers rated
at more than 100
watts per channel
RMS at 8 ohms.
TOOLS
REQUIRED
• Wire Stripper
DS00356ACN/TVC-1 Printer 11/19/03 5:00 PM Page 7