Filter
Top Products
Installation Considerations
Calculating the Impedance Magnification Setting
Use the following instructions to select the correct switch
setting for the number and type of speakers in your system.
CAUTION! EVERY SPEAKER PAIR IN THE SYSTEM MUST
BE CONNECTED TO AN IMPEDANCE-MAGNIFYING VOL-
UME CONTROL AND SET TO THE SAME MAGNIFICATION.
1. Count the number of pairs of speakers you are connecting
to the system.
2. Set the Speaker Pairs switch on the rear panel of the TVC-1
to match the number of pairs of speakers (1, 2, 3/4, 5/6).
TVC-1 Power Handling
The TVC-1 is designed for use with a receiver or amplifier hav-
ing a maximum power output of 100 watts per channel at
8 ohms. Damage caused by the use of a higher-power receiv-
er or amplifier will void the warranty. Consult your Niles deal-
er, or receiver/amplifier manufacturer, if you are uncertain
about the power rating of your receiver or amplifier.
3
T
ABLETOP STEREO
V
OLUME
C
ONTROL
8
T
ABLETOP STEREO
V
OLUME
C
ONTROL
7. Insert the smooth side of the connector plug into the
smooth side of the socket. Don’t force the scalloped side of
the connector plug into the smooth side of the socket. See
Figure 2.
The inputs of the TVC-1 are the connector terminals labeled
“AMPLIFIER”. The outputs are the connector terminals
labeled “SPEAKERS”. Be sure not to reverse these connec-
tions or the TVC-1 will not function properly.
8. Locate the pre-printed Room Labels. Affix the appropriate
label to the recessed area next to the knob on the TVC-1.
SPEAKER 4
Figure2
Connecting the
Wires
DS00356ACN/TVC-1 Printer 11/19/03 5:00 PM Page 3