Filter
Top Products
5
To ensure years of enjoyment from your NADY AUDIO ProPower™ PPA-300, please read and understand this manual
thoroughly before using the unit.
INSPECTION
Your NADY AUDIO ProPower™ PPA-300 was carefully packed at the factory in packaging designed to protect the units in
shipment. Before installing and using your unit, carefully examine the packaging and all contents for any signs of physical
damage that may have occurred in transit.
[Please note: Nady Systems is not responsible for shipping damage. If your unit is damaged, do not return to Nady, but notify
your dealer and the shipping company (if shipped to you) immediately to make a claim. Such claims must be made by the
consignee in a timely manner.]
CONTENTS
• Instruction manual
• PPA-300 (verify that the unit’s serial number is same as shown on shipping carton)
• AC Power cord
• Warranty Card
POWER CONNECTION
The PPA-300 has an internal power supply and is designed to operate from an external AC source. Power requirements
for electrical equipment differ from area to area. Be sure to confirm that the voltage is your area is 115V, 60 Hz
RACK MOUNTING
The PPA-300 amplifier is designed for standard 19" rack mounting as well as “stack” mounting without a cabinet. Use 4
screws and washers for mounting to the front rack rails. It is also a good idea to support the amps also in the rear,
especially for mobile use where the amps will be subjected to shocks.
AMPLIFIER COOLING
Also pay close attention to the cooling requirements. Never block the air vent in the back side and front of the amplifier if
the amplifier is being run at high output levels. For best results in such high output power applications you should
augment the amplifier’s air flow with a rack cooling system.
INSTALLATION