Filter
Top Products
OPERATING INSTRUCTIONS
6
Before starting to equalize your sound system there is some information you should know and procedures you should follow:
1. Set channel levels to the center detent (0dB-unity gain) on the front panel.
2. Enable the BYPASS switch (Note: The amber LED is ON).
3. Set all slide controls to the center detent or 0dB (unity gain) position.
4. Select the 6dB range switch (green LED ON).
5. Apply signal to the system.
6. Disable the BYPASS switch, amber LED OFF.
7. If the CLIP (overload) LED is on you must turn down the level control.
8. You may now start equalizing your system.
9. Switch the range switch to 12dB (red LED is lit) if the 6dB range does not provide sufcient gain.
• The GEQ-215 is equipped with a BYPASS switch with an LED indicator. If you disable the BYPASS switch, the LED will turn off and
all equalization settings will be restored. In bypass mode, the audio signal will ow through at unity gain.
• Use the range selection switch to select between a 6dB or 12dB level adjust range. The dual color range LED will indicate green for
6dB and red for 12dB.
• The level control allows adjustment between OFF (center detent) and +/-6dB.
Note: The unit is equipped with a red overload LED, which illuminates when the signal reaches 5dB prior to clipping. It is normal for the
overload LED to ash occasionally, but if the overload LED is on steady you must readjust the level control.