Filter
Top Products
GB
9
TROUBLESHOOTING
NO SOUND • Power AC lead unplugged or power not
switched on
• Tape 1 Monitor selected
• Mute on
• Rear Pre-out/Main-in amp links not fitted
• No speakers selected
• Check if AC lead is plugged in and
power switched on
• De-select Tape 1 Monitor mode
• Switch off Mute
• Fit links
• Select the appropriate speakers (A / B)
Problem Cause Solution
NO SOUND ONE CHANNEL • Balance control not centred
• Speaker not properly connected
or damaged.
• Input lead disconnected or damaged
• Centre Balance control
• Check connections and speakers
• Check leads and connections
WEAK BASS /
DIFFUSE OR NO STEREO IMAGE
• Speakers wired out of phase
• Bridge Mode selected when speakers
are connected normally
• Check connections to all speakers in
the system
• Disengage Bridge Mode
REMOTE CONTROL HANDSET NOT
WORKING
• Batteries flat, or incorrectly inserted
• IR transmitter or receiver windows
obstructed
• IR receiver in direct sun or very bright
ambient light
• Check or replace batteries
• Remove obstruction
• Place unit away from direct sun, reduce
amount of ambient light
POWER/PROTECTION LED STAYS RED
UPON TURNING POWER ON
• Loudspeakers cabling has a short-
circuit
• Turn amplifier off and check
loudspeaker cable connections for both
speakers at amplifier's back panel and
loudspeakers. Turn amplifier on.
POWER/PROTECTION INDICATOR TURNS
RED DURING OPERATION
• Amplifier has over-heated.
• Overall impedance of loudspeakers too
low
• Turn amplifier off. Make sure
ventilation slots on top and bottom of
amplifier aren't blocked. After amplifier
has cooled down, turn back on.
• Ensure the overall loudspeaker
impedance isn't below 4 ohms.
• Check loudspeaker cables for short
circuits
7. TUNER CONTROL
(for use with NAD Tuner)
BANK Selects a bank of preset stations.
PRESET or selects respectively higher or lower
number station preset.
8. CD PLAYER CONTROL
(for use with NAD CD Player)
engages Pause
engages Stop
engages Play or toggles between Play and Pause
or engages Track skip; Press once to respectively go to
the next track or to return to start of current or previous track.
NEXT DISC Go to next disc (for NAD CD changers).
9. CASSETTE DECK CONTROL
(for use with single (DECK B) or double transport (A and B) NAD
Cassette Decks).
or engages Forward Play or Reverse Play.
Record / Pause. Press to put cassette deck into record-
pause. Press Play to start recording.
Stops Play or Recording.
engages Rewind.
engages Fast Forward.
NOTES: The remote control handset supplied with the C370 is of
a universal NAD type, designed to operate several NAD models.
Some buttons on this handset are inoperative as the functions
aren't supported by the C370. The Video 2 and Video 3 input
selector buttons (inside section No. 5) on the remote control
handset are inoperative in the case of the C370.
Direct sunlight or very bright ambient lighting may affect the
operating range and angle for the remote control handset.