Filter
Top Products
Issue 1 July 2009 Page 14 of 18
INVALID TRACK
cd pr 2 tr 9
PLAY 1 0:41
cd play program
If an incorrect entry is made, say track 99 when there are only 7 tracks available on the disc, a brief error
message is displayed
If at any time you wish to add a track to the list, press the CLEAR button to obtain the next step number.
Alternatively, to delete a previous entry, press CLEAR a second time to remove the last entry. Repeated
pressing of CLEAR will then erase each step in reverse order. So to delete an entire program sequence from
the memory, press CLEAR repeatedly until “program 1” is shown in the display.
When the last track number has been entered, press PROGRAM a final time, then the PLAY button to start the
program sequence.
If you wish to check the selection before playing back your program, the CHECK button can be pressed to step
through each program entry in turn.
If during this check sequence the PLAY button is pressed, the remaining part of your programmed selection will
play to the end of the sequence.
Otherwise, to play all the programmed tracks from the beginning of the sequence, press PLAY/PAUSE, or
PLAY on the remote control directly from programming. You can also start the sequence from any point by
stepping through the programmed sequence with CHECK button until the desired starting track is displayed.
The >>| button may be pressed to jump to the next track in the programmed sequence, or |<< button to obtain
the previous track in the sequence.
When all programmed tracks have played, the CD player stops. The same track selection can then be played
again by pressing the PLAY/PAUSE button on the front panel, or PLAY on the remote control.
To repeat a programmed sequence continually, press REPEAT whilst playing the program.
To cancel this mode, press PROGRAM.
Note: The program contents will be cleared if you switch off the power, or open the arm and load
another disc. If, however, the same disc is loaded again with the power still switched on, the program
sequence is retained in the memory.
DISPLAY
The CD display brightness can be controlled in three levels by pressing the DISPLAY button on the remote
control.
The original setting is maximum brightness, but by pressing the DISPLAY button once, brightness is reduced,
and a further press turns the display off. This controls display in CD, and external source modes.
OPERATION