Filter
Top Products
Issue 1 July 2009 Page 13 of 18
PLAY
7
0
:
39
cd repeat shuff
STOP 74
cd scan intro
STOP 74
cd pr 1 tr 0
STOP 74
cd pr 2 tr 3
STOP 74
cd pr 1 tr 3
If REPEAT is then pressed whilst in shuffle mode, a repeat shuffle function is obtained
Pressing >>| selects the next track in random order.
SCAN INTRODUCTION
The scan-introduction function allows play back of just the start of each track on the disc, for instance to locate a
preferred track by ear.
Press INTRO on the remote control, and if the player has stopped, the display will show
The first ten seconds (approximately) of each track on the CD can then be played in sequence by pressing
either PLAY/PAUSE on the front panel, or PLAY on the remote control.
Press INTRO again to cancel introduction search mode. If INTRO mode is cancelled while the M6CD is still
playing, the remainder of the entire disc will be played.
PROGRAMMED PLAY
The built-in program memory allows you to store up to 99 track numbers and then play them back in the held
order. Each track is stored as a “step” in the program.
With the CD loaded and the player stopped, first press PROGRAM on the remote control. The following is then
displayed :
On the remote control, press the numeric button of the track number corresponding to the first track you wish to
store (number 3 for example). That track number will now appear in the display:
Press PROGRAM again on the remote control - the next program step is selected, (program 2) and the
program number increases, ready for a new entry with previous programmed track number still displayed.
Continue entering track numbers in the same way up to a maximum of 99. If more than 99 tracks are attempted
the memory will not accept any extra ones, and the display reverts to “program 1”.
Remember that when entering a single-digit track number, there is a delay of about two seconds before the
display accepts the entry - this is to allow time for a second button to be pressed when a double-digit number is
required.
OPERATION