Filter
Top Products
Page 4
EXISTING CONSTRUCTION
STEP 1 After you have determined the location of the speaker,
attach the mounting flanges to the mounting ring as
shown in Figure 2. Install the mounting ring in the wall
and position it so that the extending flanges are behind
the drywall material. Bend the front flanges over the
dry wall as shown in Figure 2.
STEP 2 Run a 16 gauge 4-conductor cable, such as MS164X,
from the volume control to the SUM. Then run one 2-
conductor cable such as MS16X, to each left and right
channel speaker. (See Figure 3.) A 16 gauge 4-
conductor cable should also be run from the volume
control to the system amplifier. Be sure that you se-
cure the wire (DO NOT USE STAPLES) and leave
enough wire for the speaker connections. Connect the
wires to the SUM and speakers.
Wall stud
mounting ring
flange
mounting screws
drywall screws
Shown
flange
Bend
Tabs as
Figure 2 - SAMB Mount-
ing Bracket For Existing
Construction
115958 B
IMAGE 4 OF 8