Filter
Top Products
14
From
Control
Component
HOOK-UP GUIDE
Remote “DC In” Control Hook-Up
This feature connects your PowerCenter to an automated Home Theater control system or allows another component
with a Remote “DC Out” connection to automatically turn on and off your PowerCenter.
A) Plug the AC power cable of the component you are using to control the PowerCenter into an unswitched outlet
on the PowerCenter. Note: This component must deliver a control voltage between 3-30 volts DC.
B) Plug one end of the 1/8" miniplug (supplied) into the corresponding
Remote “DC In” connection on the PowerCenter.
C) Plug the other end of the 1/8" miniplug into the Remote “DC Out”
connection on the component that you want to turn on and off
the PowerCenter’s Switched Outlets when it is turned on.
Remote “AC In” Control Hook-Up
This feature connects your PowerCenter to an automated Home
Theater control system or allows another component with an AC
outlet connection (for example, an AV receiver or preamplifier
for example) to automatically turn on and off your PowerCenter.
A) Insert the Remote “AC IN” Control cord’s female plug into the “AC IN” 100V connection.
B) Insert the Remote “AC IN” Control cord’s 2-prong male plug into a switched AC power outlet on the component
(AV receiver or preamplifier). When this device is turned on, the outlets programmed as “Switched On” on the
PowerCenter will turn on immediately. The outlets programmed as “Switched On After Delay” will turn on after
the set time delay.
From
Control
Component