Filter
Top Products
page 6powered subwoofers
WIRING WITH THE RCA JACK INPUTS
The "INPUT" RCA jacks on the back panel of your Subwoofer allow you to directly connect the Subwoofer
to preamp-level components such as surround sound processors, preamplifiers, integrated amps and receivers
with preamp outputs, Electronic High-Pass filters, crossovers, etc.
This will give you better bass quality than using the speaker inputs, because it bypasses your amp or
receiver's amplifier stage. If you don't have a Subwoofer Output available, check to see if you have preamp
outputs on your preamp, amp, or processor to be able to use these inputs. If you have only one set of preamp
outputs, use a Y-connector to feed both the amplifier and the Subwoofer.
To connect the Subwoofer in this way, simply run one or a pair of shielded RCA - RCA interconnect cables
from the output jacks on your component to the "INPUT" jacks on the Subwoofer's backplate. See Figure 1. It
is not necessary to use both input jacks on the subwoofer.
If you are using two subwoofers, use a Y-connector at the back of the amplifier or processor to split the
signal to feed both subwoofers.
FIGURE 1 - CONNECTING TO A SURROUND PROCESSOR
100
PHASE
10391 Jefferson Blvd, Culver City, CA 90232 310/204-2854 www.mksound.com
MILLER & KREISEL SOUND CORPORATION
RIGHT
INPUT
LOW PASS FILTER
(Hz)
FROM AMPLIFIER
50
75
60
125
T
2 AMP
120 VAC 50/60 Hz
RIGHT LEFT
LEFT/MONO
SLOW-BLOW
ATTENTION:
DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE.
UTILIZER UN FUSIBLE
DE RECHANGE DE MEME TYPE.
CAUTION:
DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE.
REPLACE FUSE ONLY
WITH SAME TYPE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
+
-
BASS LEVEL
+3 dB
+6 dB
- 3 dB
- 6 dB
REFERENCE
+9 dB
BYPASS
VARIABLE
!
SURROUND PROCESSOR OR RECEIVER
SUB / MONO OUT