Filter
Top Products
25
APPENDIX C: MM-4XP CABLE ASSEMBLY
ASSEMBLING EN3-TO-PHOENIX LOUDSPEAKER CABLES
To connect the MM-4XP loudspeaker directly to the MPS-488P power supply, you need an EN3 5-pin female to Phoenix
5-pin female cable. The following procedure documents how to assemble this cable. If you are starting with an EN3-to-pig-
tail cable (included with the MM-4XP), you can disregard steps 4–7 in the procedure
To assemble an EN3-to-Phoenix cable:
1. If cable has not been stripped, strip the outer shielding 1” and then strip the black, red, blue, and white wires .275”.
2. Insert the five exposed conductors into the five cable holes in the Phoenix connector using the following wiring scheme.
3. Secure the conductors by tightening the five screws in the Phoenix conductor.
Assembled EN3-to-Phoenix Cable
Phoenix 5-Pin Female Cable Mount Connector
1”
0.275”
Pin #1 Black 48 V DC (–)
Pin #2 Red 48 V DC (+)
Pin #3 Unshielded Audio shield
Pin #4 Blue Audio (–)
Pin #5 White Audio (+)
Connector side upSide (cable attached)
Tighten screws