Filter
Top Products
Page 9
Page 6
13. MODE BUTTON
Press it to select RADIO, DISC, CARD(after inserting MMC/SD card), USB(after inserting
USB bar) and auxiliary input playing mode.
14&15. MMC/SD COMPARTMENT and USB SOCKET and THEIR OPERATION
When needing to do MMC/SD or USB playing, insert the MMC/SD card or USB bar into
MMC/SD compartment or USB socket. Then the playing mode will be changed into MMC/SD
or USB mode and display CARD or USB on LCD(When MMC/SD card and USB bar are both
inserted into their compartment or socket, the playing mode will be changed into the mode of
the latter one), and then play the first track of MMC/SD or USB.
16. RELEASE BUTTON
To remove the front panel from the unit chassis, press the REL key to release the front
panel from the unit chassis, then pull it up a little to take out from the unit chassis.
17. INFRARED REMOTE CONTROL SENSOR
18. EJECT BUTTON
Press this key, a loaded disc can be to ejected.
. CLOCK BUTTON
Press the CLK button briefly to display time for 5 seconds on the display, and then returns to
its previous display unless the button is pressed again.
Then press the CLK button and hold for more than 1 seconds until the real time flashes on the
display. Then you can adjust HOUR or MINUTE by rotating the VOL knob.
20. SCAN BUTTON
Press it to scan up by one channel step with station detection. If a valid signal has detected,
the current frequency is blinked within 5 seconds, then press it again to stop scan and remain
the current frequency; otherwise, the unit continue to scan up by one channel step with station
detection 5 seconds later.
21. RESET BUTTON
Before operating the unit for the first time, or after replacing the car battery or changing the
connections. You must reset the unit.
Press this button with a cuspidal object. This operation will erase the clock setting and some
stored contents.
19