Filter
Top Products
Select FOOTSWITCH with the rotary control. (If the Foot Controller is not available, use
the rotary control to select the channels during this exercise.)
CHOOSE SWITCHING LOGIC
CHANNEL SELECT
FOOT
SWITCH
EXT
FET MIX MODE
TUBE
TUBE
HI GAIN
MIX
RETURN
EFFECTS LOOP
CROSSOVER
LOW
HIGH
0% 100%
SEND
FOOTSWITCH
FUNCTION ASSIGN
MUTE
GAIN
SELECT INSTRUMENT INPUT
ACTIVE
INSTRUMENT
INPUTS
PASSIVE
Connect your instrument to the appropriate Input jack (Active or Passive.) If your
instrument incorporates a pre-amp which uses a battery for power, you will probably want to
use the Active Input Jack. Most other instruments should work well with the Passive Input.
OUTPUT LEVEL
HI GAIN
TUBE
50%
MIX
TUBE
FET
FET
CLIP
OUTPUT LEVEL CONTROL
Important... Set the Output Level Control located in the center of the front panel to 0.
(7 O'Clock)
MIX
BALANCED
LEVEL
RETURN
EFFECTS LOOP
CROSSOVER
LOW
HIGH
0% 100%
TUNER
OUTPUT
SEND
CHANNEL SELECT
FOOT
SWITCH
EXT
FET MIX MODE
TUBE
TUBE
HI GAIN
FOOTSWITCH
FUNCTION ASSIGN
MUTE
GAIN
FOOTSWITCH
CONNECT FOOT CONTROLLER
Then connect the M-2000 's Foot Controller to its 6-Pin Male XLR Jack.
SPEAKER
OUT
SPEAKER
OUT
SPEAKER OUT
SUGGESTED LOAD 4 OHMS
600 WATTS RMS
MINIMUM LOAD 2 OHMS
SPEAKER OUT
CONNECT SPEAKER
First connect the M-2000 to your favorite speaker cabinet using either the 1/4 inch jacks or the 3-
pin XLR's.
INITIAL SET-UP
The recommended load is 4 Ohms.
PAGE 2