Filter
Top Products
Using the FM tuner
9
Selecting a station
During normal use the FM tuner should be left in the standby
state. This uses a negligible amount of electricity, but ensures
that the components of the FM tuner operate at maximum
efficiency from the moment you start listening to a station.
If you are not going to use the FM tuner for a period of several
days you should switch the unit completely off, at the back
panel, and disconnect it from the AC power supply.
To switch on from standby
● Press [ (Previous) or ] (Next).
● Switch on any other equipment connected to the FM tuner
which is not part of the Meridian 500 Series.
To select a preset station
● Press [ (Previous) or ] (Next) until the display shows the
station you want to listen to, or type the number of the preset
(remote only).
For example, for Radio 3
the display will show:
Radio 3
● Keeping either key held down will step through the preset
stations in turn.
Note that before using the FM tuner for the first time you may
need to set the preset frequencies for your area; see To
programme a preset, page 13.
To switch to standby
● Press Off.
The display will show:
.
If you have other Meridian 500 Series equipment connected to
the FM tuner, these units will also switch to standby.