Filter
Top Products
SPEAKER CONNECTION
1. Place the speakers in convenient locations on either
side of the unit or connect them to the unit as
described below.
2. Locate the Speaker Jacks on the sides of the unit and
connect the right speaker to the Right Speaker jack and
the left speaker to the Left Speaker jack.To extend the
speaker wire, connect the speaker plug into the extender
(the side with the hole) and the other side of the
extender (with the pin) into the respective speaker jack.
3
PREPARATION FOR USE
To insert the floor stands, firmly
insert a floor stand into each
speaker and the main unit as
shown.
1
To remove the floor stands, grasp
the stand as shown and pull out
the floor stand from each speaker
and the main unit.
2
INSERTING AND REMOVING THE FLOOR STANDS
If connected, remove the floor
stands by grasping the stand as
shown and pulling out the floor
stand from each speaker and the
main unit. Mount the speakers and
the main unit together as shown in
MOUNTING THE SPEAKERS
AND MAIN UNIT above.
1
HANGING THE UNIT ON A WALL
To mount the speakers and the main unit, make sure the
speakers are plugged into their respective speaker jacks,
then secure the two speakers to the main unit using the
Mounting Plate and the eight screws.
To remove the Mounting plate, reverse the procedure.
NOTE: When mounting the speakers to the main unit, if the
extended speaker wire is too long, insert the wire back into
the hole on the speaker to prevent damage to the wire.
1
MOUNTING THE SPEAKERS AND THE MAIN UNIT
Mark the three screw locations of the
Hook Plate on the desired wall using
the Hook Plate as a template, trying to
locate the screws on a stud if possible.
Hold the Hook Plate on the desired
wall (tabs facing up) and secure with
the three screws (supplied). If not
secured to a stud, use a screw/anchor
combination to secure.
2
Carefully, but firmly, place the unit
onto the Hook Plate tabs
3
CAUTION: Only connect the
speakers which are supplied
with the unit. The use of any
other or additional speakers
may cause damage to the unit.
Never operate the unit without
the speakers connected.
Connect
to speaker
jack
Original
speaker
wire