Filter
Top Products
23
AUTO ( automatic ) / MANUAL TUNING
1. Press the POWER button to switch on the system.
Select the TUNER function by pressing the TUNER /
BAND button on the front panel or remote control.
2. Press the TUNER / BAND button repeatedly until the
desired band (FM or AM) is selected.
3. For manual tuning, quickly press and release the TUN-
ING • DOWN / PREVIOUS or TUNING • UP / NEXT
button to select the desired frequency.
4. For auto tuning, press and hold the TUNING • DOWN /
PREVIOUS or TUNING • UP / NEXT button for 1 sec-
ond. The system will search until a station of sufficient
strength is found. If the station is not the desired one,
simply press and hold the TUNING • DOWN / PREVI-
OUS or TUNING • UP / NEXT button for 1 second again.
Weak stations are skipped during automatic tuning.
NOTE: When tuning, the sound will be muted to eliminate
interfering background noises. When a station is found,
the audio signal will come back on.
²
STEREO
²
will ap-
pear on the display when an FM-stereo signal is received.
With weak FM stereo signals, you may hear static or back-
ground noise. These noises can be suppressed by switch-
ing to MONO. Simply press the ST./NOR. & MONO
/H.S.D. button to select MONO mode.
²
STEREO
²
will
disappear from the display.
TUNER
PRESET MEMORY
Storing preset stations
You can store preferred stations in the TUNER¢s memory
(Each 20 stations for FM and AM).
1. Press TUNER / BAND button to select TUNER func-
tion and FM or AM band.
2. Press the TUNING • DOWN / PREVIOUS or TUNING
• UP / NEXT button to select the frequency you wish to
store.
3. Press MEMO / C-ADJ button, the “Memory” indicator
will flash, then press REPEAT / MEMO • UP or STOP
/ MEMO • DOWN or 0-9/+10 digit buttons to select the
desired location to be preset.
4. Press MEMO / C-ADJ button again to store the station
into the designated location.
5. To set another preset station, follow steps 2 to 4.
Selecting preset stations
1. Select the TUNER function and FM or AM band with
the TUNER / BAND button on the front panel or remote
control.
2. Press the REPEAT / MEMO •UP or STOP / MEMO
•DN button on the front panel or remote control until
the required preset memory number appears. Or press
the 0-9/+10 digit buttons on the remote control to se-
lect the preset stations directly.