Filter
Top Products
4
INSTALLATION
To Install/Remove the Belt Clip
To install, place belt clip into hole in the rear of the unit and slide up until it
locks in place.
To remove, press in the top part of the belt clip and slide downward.
Battery Installation
Batteries need to be replaced when stations are difficult to tune in. Make
sure the Belt Clip is removed first.
1. Open the battery compartment door on the rear of the unit by inserting a
small screwdriver, paper clip or similar item into the tab while gently
pushing to remove.(see figure below).
2. Insert two (2) “AAA” batteries (not included) according to the polarity
diagram. Alkaline
batteries are recom-
mended for longer
playing time.
+
+
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated next
to the battery compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or
old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to
prevent damage or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat
and rupture. (Follow battery manufacturer’s directions.)
DR1000.O/M.QXD 1/21/03 7:26 AM Page 4