Filter
Top Products
14
McIntosh Single Channel Amplifier Number One
How to Prepare Hookup Cables
How to Connect using three Amplifiers
McIntosh Single Channel Amplifier Number Two
McIntosh Single Channel Amplifier Number Three
The McIntosh XRT28 Loudspeaker System utilizes bind-
ing posts for speaker wire connections. Prepare the Loud-
speaker Hookup Cables that attach to the Power Amplifier
Output Terminals:
Bare wire cable ends:
Carefully remove sufficient insulation from the cable
ends, refer to figures 19, 20 & 21. If the cable is
stranded, carefully twist the strands together as tightly
as possible.
Note: If desired,
the twisted
ends can be
tinned with
solder to
keep the
strands together and/or attach a spade lug.
Spade lug or prepared wire connection:
Insert the spade lug connector or prepared section of
the cable end into the terminal side access hole, and
tighten the terminal cap until the cable is firmly
clamped
into the
terminal
so the
wires
cannot
slip out. Refer to figures 22, 23 & 24.
1. Remove all the jumpers between the Binding Posts and
retain them for possible future use.
2. Connect a Loudspeaker cable from the Negative (-)
Binding Post of the Amplifier Number One to the
XRT28 Loudspeaker System LOW COMmon (-) Bind-
ing Post.
3. Connect a Loudspeaker cable from the Positive (+)
Binding Post of the Amplifier Number One to the
XRT28 Loudspeaker System LOW 4S (+) Binding
Post.
4. Connect a Loudspeaker cable from the Negative (-)
Binding Post of the Amplifier Number Two to the
XRT28 Loudspeaker System MID COMmon (-) Bind-
ing Post.
5. Connect a Loudspeaker cable from the Positive (+)
Binding Post of the Amplifier Number Two to the
XRT28 Loudspeaker System MID 4S (+) Binding Post.
6. Connect a Loudspeaker cable from the Negative (-)
Binding Post of the Amplifier Number Three to the
XRT28 Loudspeaker System HIGH COMmon (-) Bind-
ing Post.
7. Connect a Loudspeaker cable from the Positive (+)
Binding Post of the Amplifier Number Three to the
XRT28 Loudspeaker System HIGH 4S (+) Binding
Post.
8. Tighten all of the Loudspeaker and Amplifier Binding
Posts.