Filter
Top Products
11
How to Prepare Hookup Cables
The McIntosh XR27 Loudspeaker System utilizes binding
posts for speaker wire connections. Prepare the Loud-
speaker Hookup Cables that attach to the Power Amplifier
Output Terminals:
Bare wire cable ends:
Carefully remove sufficient insulation from the cable
ends, refer to figures 20, 21 & 22. If the cable is
stranded, care-
fully twist the
strands to-
gether as
tightly as pos-
sible.
Note: If desired, the twisted ends can be tinned with
solder to keep the strands together and/or attach a
spade lug.
Spade lug or prepared wire connection:
Insert the spade lug connector or prepared section of
the cable end into the terminal side access hole, and
tighten the terminal cap until the cable is firmly
clamped into the terminal so the wires cannot slip out.
Refer to figures 23, 24 & 25.
Connections using a single Amplifier
McIntosh Single Channel Amplifier
1. Connect a Loudspeaker cable from the Negative (-)
Binding Post of the Amplifier to the XR27 LOW
COMmon (-) Binding Post.
2. Connect a Loudspeaker cable from the Positive (+)
Binding Post of the Amplifier to the XR27 LOW 4S (+)
Binding Post.
Note: The LOW and MID/HIGH COMmon (-) Binding Posts
must have a jumper installed between them. Likewise
the LOW and MID/HIGH 4S (+) Binding Posts must
also have a jumper installed between them. If the XR27
Loudspeaker is installed into wall, use the IN-WALL
Binding Posts instead of the LOW Binding Posts.
3. Tighten all of the Loudspeaker and Amplifier Binding
Posts.
How to Connect using a single Amplifier