Filter
Top Products
Chapter 3: Setup and Operation 9
Configuring and Connecting
AC Power
Be sure to follow the instructions in this section
for the proper configuration of fuses and voltage
settings.
Setting the Voltage
Make sure the Voltage Selector setting on each
speaker matches your local voltage (100–120V
or 220–240V).
Installing a Fuse
A 2.5 Amp fuse is required for both the
100–120V or 220–240V settings.
To change the fuse:
1 Turn off power to the speaker and disconnect
the AC power cord.
2 Use a small screwdriver to remove the fuse
holder.
3 Remove the currently installed fuse.
4 Install the new fuse in the fuse holder.
5 Replace the fuse holder so that it clicks into
place.
DSM2 speakers must be manually config-
ured for the voltage in your area. Always
check the voltage setting and fuse rating, as
described below, before connecting and
powering your speakers.
Voltage selector
Voltage
selector
Make sure to use a fuse rated at 2.5 Amps.
Do not use fuses of any other rating, or you
risk damage to the unit
Fuse holder
Fuse
holder