Filter
Top Products
With horizontal bi-amping, one amplifier drives the high
pass (ESL) section while the second amplifier drives the
low pass (WOOFER) section. To horizontally bi-amp your
Prodigys you must loosen the binding posts and remove the
jumper clips. Connect the low frequency amplifier to the
lower set of binding posts of both speakers. Connect the high
frequency amplifier to the upper set of binding posts.
Next, connect the left and right preamplifier outputs to the
appropriate left and right inputs of both amplifiers (See
Figure 3).
Vertical Passive Bi-Amplification
The very nature of vertical bi-amping dictates that both
amplifiers be identical. With vertical bi-amping, each of
the stereo amplifiers is dedicated to one speaker. For
instance, the left channel of each amplifier drives the low
pass (WOOFER) section while the right channel drives the
high pass (ESL) section. To vertically bi-amp your Prodigys
you must loosen the binding posts and remove the jumper
clips from both speakers. Starting with one speaker, connect
the right channel to the lower binding posts and the left
channel to the upper binding posts. Repeat the same procedure
for the other speaker. Connect the left preamplifier outputs
to both inputs of the left channel amplifier and the right
preamplifier outputs to both inputs of the right channel
speaker (See Figure 4).
Bass Control Switch
On the rear panel of the Prodigy electronics module, beside
the Signal Input binding posts, is a two position Bass Control
switch that allows you to select the type of low frequency
response you desire.
The 0 dB (flat) position is considered the normal setting for
most rooms. However, if you feel that the bass in your system
is too weak relative to the mid and high frequencies,
simply
select the +3 dB position. This switch position will increase
the output of the woofer by 3 dB centered around 50Hz.
Some experimentation with these two switch settings will
allow you to find the optimal tonal balance for your specific
taste, room and equipment.
Figure 3. Horizontal passive bi-amplification. One Channel shown.
High AAmplifier
speaker output
Low AAmplifier
speaker output
ESL
Woofer
Jumper clips
removed
PRODIGY
TM
Bass CControl
flat
+3db
Figure 4. Vertical passive bi-amplification. One Channel shown.
Left CChannel AAmplifier
speaker output
ESL
Woofer
Jumper clips
removed
P
RODIGY
TM
Bass CControl
flat
+3db
Operation 9