Filter
Top Products
5
Unpacking and placement
Unpack your Nº26 Preamplifier and PLS-226 Power Supply, and keep all
packing materials for future transport. Remove all accessories from the
cartons.
Carefully inspect the product for damage and flaws. If you find any,
see your Mark Levinson dealer immediately.
Place the Nº26 as close as possible to the source equipment, thus
keeping interconnect cabling as short as possible. It may be placed
on a shelf or in a cabinet where it's convenient to operate.
A one-meter DC cable is provided to connect the PLS-226 to the Nº26.
This allows you to place the PLS-226 so that it won't induce hum in the
Nº26 and other sensitive components. If you're placing the Nº26 and
PLS-226 adjacent to each other, place the PLS-226 to the right of the
Nº26 (viewed from the front). You should also place associated
equipment so that it doesn't induce hum in the Nº26 and other
sensitive components.
Be sure to allow 3 to 4 inches of clearance above both the Nº26 and
the PLS-226, to allow heat dissipation through air circulation.
Drawings are included in this manual to facilitate special installations
and custom cabinetry (see "Dimensions").
For your protection, review "Important safety instructions" before you
install your Nº26.
PRECAUTION
Unpacking
Placement
Ventilation