Filter
Top Products
11
ENGLISH
TROUBLESHOOTING
If your Tuner should not perform as expected, consult the table below to see if the problem can be corrected before seeking
help from your dealer or our service organization.
Symptom
No sound
Only noise is heard
Broadcasting is received but
with noise
Cause
•
INPUT SELECTOR of amplifier is not
Select “TUNER” in INPUT SELECTOR.
• Volume of amplifier positioned in
“MIN.”
• The terminal for system connection is
pullet out.
• The antenna is pulled out.
•
The frequency is not detected exactly.
•
The position of antenna is not suitable.
• The power of CD player is turned on.
Measures
• Set to “TUNER”.
• Adjust Volume accordingly.
• Connection correctly.
• Connect the antenna on the rear
panel.
• Set the frequency correctly.
• Install the antenna again after
locating the best reception position.
• Turn off CD player.
Page
–
–
6
6
7
6
–
7
WHEN TO USE RESET SWITCH
• When this system is subjected to an electrical shock.
• When the power is irregular.
In the above cases, function buttons may not often
operate or the display may operate wrongly. In these
cases, try the following:
Press the RESET switch lightly once or twice with a pencil
or a ballpoint pen.
7
CARE AND MAIN TENANCE
This section describes the care and maintenance tasks that
must be performed to optimize the operation of your
Marantz equipment.
7
CLEANING OF EQUIPMENT
EXTERNAL SURFACES
The exterior finish of your ST6001 will last indefinitely with
proper care and cleaning. Never use scouring pads, steel
wool, scouring powders or harsh chemical agents (e.g., lye
solution), alcohol, thinners, benzine, insecticide or other
volatile substances as these will mar the finish of the
equipment. Likewise, never use cloths containing chemical
substances. If the equipment gets dirty, wipe the external
surfaces with a soft, lint-free cloth.
If the equipment becomes heavily soiled:
– dilute some washing up liquid in water, in a ratio of one
part detergent to six parts water;
– dip a soft, lint free cloth in the solution and wring the cloth
out until it is damp;
– wipe the equipment with the damp cloth;
– dry the equipment by wiping it with a dry cloth.
7
REPAIRS
Only the most competent and qualified service technicians
should be allowed to service your unit. Marantz and its
factory trained warranty station personnel have the
knowledge and special equipment needed for the repair and
calibration of this precision instrument.
In the event of difficulty, call the proper toll-free telephone
number listed on the face of the warranty to obtain the name
and address of the Marantz Authorized Service Center
nearest you. In many cases, the dealer where you
purchased your Marantz unit may be equipped to provide
service. Please include the model, serial number of your unit
together with a copy of your purchase receipt and a full
description of what you feel is abnormal in its behaviour.
Memory backup
In case a power outage occurs or the power cord is
accidentally unplugged, the ST6001 is equipped with a
backup function to prevent memory data such as the
preset memory from being erased.
The memory funcitons are backed up for up to about
one week.
OTHERS
— Rear panel —
RESET
REMOTE
LINE OUT
L
R
CONTROL
RESET SWITCH