Filter
Top Products
14
ENGLISH
LISTENING TO THE RADIO
MANUAL TUNING
AUTO TUNING
1 To select the tuner as the source, press the TUNER button on the
front panel or the TUNER button on the remote control unit.
2 Press the TUNER button on the front panel or press the TUNER
button on the remote control unit to select the desired frequency
band if required.
3 In the preset tuning mode, press the F/P button on the front panel
to change to the manual tuning mode.
4 Press the TUNING/PRESET or button on the front panel or
TUNE/SEARCH or button on the remote control unit for
more than 1 second to start the Auto tuning function.
FREQUENCY DIRECT CALL
1 Press F.DIRECT button in the tuner mode on the remote control
unit.
2 Display shows “F-DIR-IN”.
3 Input your desired frequency with ten key buttons on the remote
control unit.
E.g.) 98.1 MHz: Press 9, 8, 1 and 0
4 It displays fixed frequency and broadcast is received.
1 To select the tuner as the source, press the TUNER button on the
front panel or the TUNER button on the remote control unit.
2 Press the TUNER button on the front panel or press the TUNER
button on the remote control unit to select the desired frequency
band if required.
3 In the preset tuning mode, press the F/P button on the front panel
to change to the manual tuning mode.
4 Press the TUNING/PRESET or button on the front panel or
press the TUNE/SEARCH or button on the remote control
unit to change the frequency.
When FM has been selected, the current mode is displayed when the
MODE button on the front panel or the T.MODE button on the remote
control unit is pressed once, and the screen changes when the same
button is pressed again while the current mode is displayed.
When “AUTO” mode is selected, “AUTO” appears on the front display
about 2 seconds. FM stations that broadcast in stereo will be received
in stereo and the “STEREO” indicator lights up.
If the signal is weak, it may be impossible to tune into the station in
stereo. In such as a case, press the MODE button on the front panel or
press the T.MODE button on the remote control unit. “MONO” appears
on the front display about 2 seconds and the program is received as
the monaural mode.
To return to stereo, press the MODE button or T.MODE button again.
Some noise may be heard, but the sound will not cut in and out as it
would if stereo was selected.
SPEAKERS
DISPLAY OFF
JOG MODE
MUTE
SLEEP
SPEAKERS
S-DIRECT
B
A
CLEAR
F/P
MODE
TUNING/PRESET
MEMORY
TUNER
CD
TAPE
PHONO
DVD VCR
DSS
CDR/MD
DOWN
1,2
34
AMPDSSVCRDVD
TAPEMDCDR
CD PHONO TUNER VOLUME
TREBLEBASSINPUTDIRECTION
PAUSEREC
RC4320SR
SYSTEM REMOTE CONTROLLER
TUNE/SEARCH
CH SKIP CH SKIP
4
1,2