Marantz PM-11S1 Stereo Amplifier User Manual


 
2
ENGLISH
ENGLISH
77
77
7 Equipment mains working setting
Your Marantz product has been prepared to comply with the
household power and safety requirements that exist in your
area.
PM-11S1 can be powered by 120V AC only.
77
77
7 Do Not Locate in the Following
Places
To ensure long-lasting use, do not locate the PM-11S1 where:
Exposed to direct sunlight.
Near to sources of heat such as heaters.
Highly humid or poorly ventilated.
Dusty.
Subjected to mechanical vibrations.
On wobbly, inclined or otherwise unstable surfaces
Radiated heat is blocked such as in cramped audio racks.
To ensure proper heat radiation, ensure the below clear-
ance from walls and other equipment.
77
77
7 Keep Objects Off
Keep objects off the PM-11S1. Blocking the vent can result in
accident and damage.
77
77
7 Do Not Touch Hot Spots During
and Immediately After Use
During and immediately after use, the PM-11S1 is hot in ar-
eas other than the controls and rear panel connection jacks.
Do not touch hot spots and especially the top panel. Contact
with hot areas can cause burns.
BEFORE USE
L
TRIM
RC-11PMS1
FM/BAM/A
RETURN
TOP MENU
MENU
VOLUME
CLOSE
MODE
PHONO
CD
BALANCED
RECORDER 1
LINE 1
RECORDER 2
LINE 2
EXIT
TONE
ENTER
DISPLAY
ATT
SCAN
RANDOM REPEAT
+
-
OPEN/ SOUND
R
INTEGRARED AMPLIFIER PM-11S1
POWER ON/OFF
PHONES
VOLUME
A
TONE
SPEAKER
B
SPEAKER
REC OUT
PRE OUT
ATT.
MC
OPERATE
PHONO
DISPLAY
SELECTOR
INPUT
Left
3-15/16 ins.
(10 cm) or more
Above
7-7/8 ins.
(20 cm) or more
Right
3-15/16 ins.
(10 cm) or more
Rear
3-15/16 ins.
(10 cm) or more
77
77
7 Battery Handling
Improper use of dry cell batteries can result in electrolyte leaks,
rupture and corrosion. Read the following precautions before
use.
If not planning to use the remote controller for an extended
period of 1 month or more, remove the batteries.
Do not mix old batteries with new batteries.
Load batteries in the proper direction indicated on the re-
mote controller.
Do not mix batteries of differing type. Even batteries of the
same shape and size can have differing voltages.
If batteries leak, wipe the case clean of any adhering elec-
trolyte and replace the old batteries with new batteries.
77
77
7 Accessories Check
Before use, check the below accessories were included in the
package.
AC power cable
The power cable included in the package can be used with
the PM-11S1 only. It cannot be used with other equipment.
RC-11PMS1 remote controller
AAA batteries x 2
Instruction Manual (This manual)
04.10.15, 4:00 AMPage 2