Filter
Top Products
16
ENGLISH
ENGLISH
ATTENUATION (ATT)
Attenuation is a one-touch feature for reducing volume level.
When the ATT button on either the PM-11S1 or the remote
controller is pressed, the volume level is attenuated. When the
PM-11S1 is shipped from the factory, the attenuation level is
set to –20 dB, but it can be set to –20 dB, -40 dB or -∞.
1. When the ATT button on either the PM-11S1 or the remote
controller is pressed, “ATT” flashes on the display and the
volume level is reduced. When the ATT button is pressed
again or the volume is increased/decreased from the
controls, the mode is canceled and the original volume
level is restored.
2. When the volume level is at -∞ (muted) and the ATT button
is pressed, the below display appears for about 3 seconds
and attenuation is not applied.
77
77
7 How to Set Attenuation Level
Attenuation level cannot be set from the remote controller.
1. Press and hold the ATT button on the PM-11S1 for 2
seconds or longer.
The attenuation level will appear on the display.
HOW TO USE AND SET FEATURES
2. Set the attenuation level. The setting changes with each
press of the ATT button on the PM-11S1.
3. When the desired attenuation level setting appears on the
display, leave it unchanged for 2 seconds or longer to enter
the setting. Once entered, the display returns to the volume
level indication.
HOW TO OPERATE THE SIDE
ILLUMINATION
The side illumination has an always-ON mode and an always-
OFF mode. In the always-ON mode, the side illumination turns
ON/OFF in sync with the display.
1. With the side illumination lit, press and hold the DISPLAY
button for 3 seconds or longer. The side illumination goes
out and the always-OFF mode is engaged.
2. To cancel the always-OFF mode and turn the side
illumination ON, press and hold the DISPLAY button for 3
seconds or longer.
INTEGRARED AMPLIFIER PM-11S1
POWER ON/OFF
PHONES
VOLUME
A
TONE
SPEAKER
B
SPEAKER
REC OUT
PRE OUT
ATT.
MC
OPERATE
PHONO
DISPLAY
SELECTOR
INPUT
DISPLAY button
ATT button
Side illumination
04.10.15, 4:06 AMPage 16