English
❖ Setting Up Manual Edit
1. In the stop mode, select the manual edit mode.
Press EDIT button twice on the unit or EDIT button
twice on the remote control.
or
2. Select the tape length as you do in “Making auto
edit” procedure.
3. Press PROGRAM button on the unit or the
PROGRAM button on the remote control to
manually edit the tracks to be recorded.
or
4. Edit the tracks for the side A repeating steps 3 and
4 in “Playing Tracks in Any Sequence (Programmed
Play)” procedure on page 15.
Note :
•
During manual edit, if the "-" indicator in the time display
disappears and “
\ ” flickers, it means that the total
time of the edited tracks exceeds the tape length. So
you should edit again.
• When a track with a number greater than 30 is edited,
the time display may show "- -- : --".
• Manual edit is only available on the current disc. If you
press
Disc selector or DISC SKIP buttons, the unit
exits from edit mode.
5. Press EDIT button on the unit or the EDIT button
on the remote control to start editing for the side B.
or
6. Do the above step 4 to edit the tracks for the side B.
• If the PLAY button is pressed after editing the
tracks, play starts from the first track of the side A
for recording.
• If all tracks of the side A have been played, press
the PLAY button to start play from the first track of
the side B for recording.
