Filter
Top Products
10
ENGLISH
REAR PANEL
NAMES AND FUNCTIONS OF PARTS
A PHONO GND Terminal
Connect the grounding wire from an analog record player
here.
B PHONO Input Jacks
These jacks are for connecting to an analog record player.
Both MC and MM cartridges can be used, therefore set
the PHONO MC button on the front panel according to the
type of cartridge you are using.
In the bi-amp mode, the R channel jack cannot be used.
C CD Input Jacks
These jacks are for connecting to the output jacks of a
Super Audio CD player, CD player, etc.
In the bi-amp mode, the R channel jack cannot be used.
D LINE 1/2 Input Jacks
These jacks are for connecting to the output jacks of a
tuner, DVD player, etc.
In the bi-amp mode, the R channel jack cannot be used.
E RECORDER 1/2 IN Jacks
These jacks are for connecting to the output jacks of a
CD-R, MD deck, tape deck, etc.
In the bi-amp mode, the R channel jack cannot be used.
F RECORDER 1/2 OUT Jacks
These jacks are for connecting to the recording input jacks
of a CD-R, MD deck, tape deck, etc. Output signals can be
turned ON/OFF from the REC OUT button on the front
panel.
G PRE OUT Jacks
These jacks are for connecting to the input jacks of an-
other main amplifier or active subwoofer. Output signals
can be turned ON/OFF from the PRE OUT button on the
front panel.
In the bi-amp mode, the signals input to the L channel are
output to both output jacks.
H SPEAKER SYSTEMS Output Terminals
These terminals are for connecting a speaker system.
Speaker output can be turned ON/OFF from the SPEAK-
ERS button on the front panel.
In the bi-amp mode, the signals input to the L channel are
output to both output terminals.
I REMOTE CONTROL Jacks
These jacks are for connecting components that are ca-
pable of remote control (D.BUS jacks) such as a Marantz
Super Audio CD Player or DVD Player. This enables these
other components to be operated with the remote control-
ler included with the PM-15S1.
See “REMOTE CONTROL JACKS” on pg. 20.