Filter
Top Products
16. 60" VERSION 2 RIBBON TWEETER REPLACEMENT
Tools Needed: #2 Phillips Screwdriver
Needle Nose Pliers
1. Place protective cover over backside of
ribbon tweeter, as shown (to prevent
damage to ribbon while moving the
speaker panel).
2. Carefully lay speaker on a flat table or
working surface.
3. Remove the protective cover and pry
away the two end covers.
4. Pull off the connector at each end of
the ribbon tweeter with a pair of needle
nose pliers.
5. Reinstall protective cover over ribbon.
6. Remove the screws that attach the
ribbon tweeter to the frame and then
remove the tweeter.
7. Install the new ribbon tweeter in the
frame. Serial number label must be at
the bottom.
8. Insert the screws. (Tighten until snug,
then back off ½ revolution.)
9. Remove protective cover and reattach
connectors to the ribbon lugs.
10. Peel liner from back of end covers and
adhere to each end of tweeter.
11. Install protective cover.
12. Reposition speakers in listening
position and remove protective cover.
13. Pack old tweeter(s) in the tube and
packing provided and return to your
dealer or Magnepan.
CAUTION: Do not bump of touch the ribbon at its end terminals. Also do not tug on the fine
wire jumper that is soldered to the foil and attached to the end terminal. All ribbon tweeters
returned to the factory MUST be returned in the factory packing.